Platform setup

The first thing that you do is connecting 2 wires inside of platform.

Thread 2 screws through the holes and twist them for connecting the stick.

Wires should be under the platform.

Don't forget to plug platfor to the socket.

Use power bank for charging GoPro. Check Porbale charger 20000 mAh.

Please check our instruction about GoPro connection

We connect it with ties.

You can set any angle of stick that you want(we usually use 2 or 3 hole).

You can change the height of the stick.

Minimum lenght is 55 cm. Maximum is 153 cm. It's enought for chilrden and adults.

You need to pull little door that closes connectors for taking it off.

Take battery from GoPro and connect wire from power bank.

You need to connect 1 usb to your laptop. Also you will need to connect ethernet wire or usb modem for having an internet(wi-fi will be taken by GoPro). Spinner program can work without internet but you will need it for sharing.

If you laptop doesn't see the platform, then install drivers.

This is a remote controller for spinning and recording.

Plug usb to the laptop and add 2 batteries AAA to make it work.

Right button is for starting spinning and left button for starting recording.

It stops automatically.

Other articles that you may like:

How to connect GoPro Gallery settings Licence transfer